Regular Care

admin Uncategorized

Ca regularly for your stone surfacesring
Natural stone surfaces that are regularly and correctly maintained will retain their magnificent look and feel for longer.

Benchtops
Clean the stone surface with a recommended product such as S-P Cleaner and a soft damp cloth after use to avoid the build up of bacteria and substances that may scratch or etch the surface. Acidic substances such as juice, coffee, tea, vinegar and wine will etch the surface of marble or limestone benchtops if left so remove spills immediately. Rinse the area after cleaning with fresh water to remove all excess dirt and detergent and dry with a soft cloth. DO NOT use abrasive cleaners or scourers, as scratches are highly visible on a glossy surface.

Floors
Sweep floors on a daily basis to prevent dirt from scratching the surface under foot and accumulating in the grout. A broom with soft bristles may be used but the most effective and gentle method for cleaning smooth surfaces is to use a Microfibre Mop, which has a soft pad. It can be used wet or dry. The mop we recommend comes with a large swivel head which makes sweeping quick and easy. It picks up the dirt and dust as it glides and can be easily manoeuvred into corners. The microfibre pad can then be removed and rinsed thoroughly.
Vacuum rough textured surfaces, as this is more effective than sweeping. The suction will pull the dirt from within the textured surface. Ensure that the vacuum cleaner wheels do not have grit on them and that the felt on the head of the suction end is not worn so these do not scratch the floor.
Mop on a regular basis after sweeping or vacuuming. Damp mopping can be carried out with a damp Microfibre Mop to pick up any residual dirt after sweeping. Wet mopping or washing should be carried out with a wet Microfibre Mop, warm water and a recommended product such as S-P Cleaner, to give a more thorough clean. Change the water regularly so that dirt is not continually transferred back to the floor. Rinse the floor after mopping to ensure the dirty water is completely removed from the surface. Wipe the floor with a cloth or towel as this will dry the floor and remove any residue and streaks. Regularity of cleaning will depend on the traffic and condition of the floor.

Showers
Remove soap scum effectively by using a recommended product such as Stone Deep Clean and a recommended white pad scourer only such as the Scrub-a-dub. DO NOT use acidic or abrasive products such as Ajax, Jif, Exit Mould, Domestos, Shower Power etc as these will dull the surface of the stone, especially marble and limestone. To prevent the build up of soap scum and mould the cleaner must be gentle enough not to damage the surface but effective enough to cut through the build-up and kill bacteria.

Remove mould effectively by using a mild bleach solution of 1 cup household bleach to 4 cups water and apply with a sponge, only to the affected areas. Leave on for no more than ten minutes then rinse off thoroughly with water. DO NOT allow bleach to accumulate on the floor of the shower, as it will dull the surface. Rinse the entire area. DO NOT mix bleach with ammonia, as it will cause a toxic chemical reaction. Be aware that over time if not done correctly this procedure may dull the surface of some stones.
Dry the area as thoroughly as possible after cleaning to prevent the growth of mould and mildew. Use a dry sponge, towel or squeegee to wipe away the excess moisture. Ventilation is also essential. Stone tiles in showers must be sealed professionally after installation and silicon applied in the corners and around edges to prevent moisture from accumulating behind the tiles. The grout must also be sealed professionally to prevent it from holding water and encouraging mould growth. A well designed shower with good fall towards the drain is a major help in keeping the area mould free.

Outdoor areas
Sweep outdoor areas weekly with a medium bristled brush, as dirt can accumulate quickly and settle in the grooves of textured surfaces.

Hose the surface monthly using clean water and a mild neutral stone detergent such as S-P Cleaner to remove excess dirt. A heavy duty clean should be carried out yearly. If neglected, outdoor areas can look dull and stained due to the accumulation of dirt and pollutants. Many outdoor areas have slip resistant, textured surfaces, which can become difficult to clean if left too long without maintenance.

Remove organic growth such as algae, moss or lichen as soon as possible using only a scourer recommended by your stone care professional such as the white Scrub-a-dub. DO NOT use a wire brush. Clean the area with a sponge and a mild chlorine solution of 1cup chlorine to 4 cups water to kill bacteria. Leave on for no longer than 10 minutes then rinse off thoroughly. Organic growths are usually moist and can stain stone if not removed.

Furniture and ornaments
Dust furniture and ornaments regularly with a damp cloth to trap any dirt on the surface of the stone as a build up of dust, oils and dirt, can etch the surface of some stones. Repeat with a clean, dry, soft cloth to polish and remove streaks.

Clean monthly with a recommended product such as S-P Cleaner, but DO NOT use products such as Mr Sheen as these will leave a waxy build up on the surface of the furniture or ornaments. As furniture and ornaments are not subject to the same wear as a stone floor they do not need cleaning with detergent as often. Regular dusting and wiping with warm water and a soft cloth should suffice.

Clean monthly with recommended products.

Share this Post