marble_banner

Our Products | Floors

Stone Deep Clean

Stone Deep Clean is a deep cleaning product. It is highly effective for breaking down soap scum build up on baths and showers, on both natural stone and glass surfaces. This cleaner is a neutral PH detergent and will not damage your surfaces. As this is a stronger cleaner than the Rejuvenata and must be rinsed off thoroughly. Ideally it should be used in showers at least once per week to reduce the build up of mould and soap scum.

Instructions for Use
Step 1: Mix 1 part Stone Deep Clean to 1 part water in a spray bottle.
Step 2: Wet the shower walls with water
Step 3: Spray the mixed Stone Deep Clean on one wall at a time so the solution does not dry out (approximately 9 sprays per wall)
Step 4: Use the special white nylon pad recommended for use with the cleaner (Scrub-a-dub) to spread the cleaner evenly over the entire wall. (DO NOT use other scourers ie green scourers as they will scratch stone and glass)
Step 5: Starting from the top and working your way down, scrub the wall with the white pad using circular motions. Use only moderate pressure when scrubbing
Step 6: Wash down the scrubbed wall thoroughly with clean water. The wall should look fresh and sparkling. If scum remains after rinsing, wet the pad with water and cleaner accumulated in the bottom of the shower and repeat the scrubbing process in the stubborn areas.

If suds appear on the area, this means the soap is being removed. If normal scrubbing does not remove the soap scum or mould call your stone care professional. They will be able to remove the stubborn excess and prepare your surface so that regular cleaning with Stone Deep Clean will be effective.
Ideally have the area cleaned first by a professional before using Stone Deep Clean for the first time, to prepare the surface for effective regular cleaning. Only use the recommended white Scrub-a-dub pad as general household scourers will scratch and damage stone surfaces.

Dry-Treat Rejuvenator

S-P Cleaner is an excellent neutral PH, everyday cleaner for your stone benchtops and floors. It will clean dirt and grime off the stone and leave surfaces fresh and sparkling. It will also reduce streaking which is a common concern with natural stone surfaces.
S-P Cleaner contains a small amount of the penetrating sealer used by The Marble Man. This ensures that every time the cleaner is applied, the penetrating sealer in the stone is ‘topped up’, providing added protection. S-P Cleaner may be used on a daily basis and should be used a minimum of once per week.

Instructions for Use:
Benchtops
Step 1: Mix 1 part S-P Cleaner to 40 parts water in a spray bottle.
Step 2: Spray the mixed S-P Cleaner onto the benchtop (Approximately 1 spray per ½ m2). Too much product will cause streaking.
Step 3: Using a paper towel wipe the surface dry. DO NOT use scourers or wet sponges.

Floors
Step 1: Mix 100ml of S-P Cleaner in half a bucket of warm water
Step 2: Using a damp Microfibre Mop clean the floor with the solution from the bucket. A damp rather than wet mop will leave fewer streaks

No need to rinse this product off with water as it acts as a rinsing product. Imperfections and streaks are more noticeable on high gloss surfaces therefore benchtops and floors must be dried with a clean towel to achieve a mirror finish.
Ideally have the area cleaned first by a professional before using S-P Cleaner for the first time, to prepare the surface for effective regular cleaning.